User's Manual

receive and show the corresponding value when the fuel transmitter send the
TRMS-RFS-FS006 signal in the extent permitted.
B) Secondly, the red LED of the receiver will flash when the receiver receive the
signal from the door status detector, it will flash once when the first door
opened, flash twice when the second door opened, and so on. The TRMS-200
will get into the learning mode when it first receive the door-opened
TRMS-RFS-DS002 signal from the door status detector, and save the
corresponding ID of the door status detector, it will auto exit the learning
mode after finishing learning mode. When power off the TRMS-200, it also
save the ID again.
In the use of the process, if the LED flash a faint light or not flash when the
TRMS-200 receive the status signal which the door opened status or fuel status be
changed from the fuel transmitter or the door status detector, It means low batteries,
please change other machine and get into learning mode anew
TRMS-200 will consume a certain electric quantity when it is working, please
power off if not used for a long period of time, lest the power run out and can not
launch the Reefer engine.
This device complies with Part of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference received, including interference that may
cause undesired operation
Caution content:
changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment