User's Manual

Programming Personal Override code

A personal override code will be a sequence of left – right - left turn signal flashes that can be used if

the remote is lost to disable the alarm:

Enter programming Mode

1. Manually disarm system

2. Turn ignition on – off – on – off – on. The siren will chirp one time to confirm.

3. Press and hold button 1 and 2 for a few seconds until alarm chirps 3 times and flashes light 3

times to confirm.

Select number of flashes for Code

The code will be a combination of left-right-left-right turn signal count.

1. Turn on left turn signal to desired number of flashes. (up to 9)

2. Turn on right turn signal to desired number of flashes. (up to 9)

3. Turn on left turn signal to desired number of flashes. (up to 9)

4. Turn on right turn signal to desired number of flashes. (up to 9)

5. The remote will display the sequence on the screen when done.

6. The bike will flash the code in the same sequence entered.

Using code in case of lost remote

1. Turn ignition key to on position. Let alarm go thru a full cycle until the turn signal lights stop

flashing. (If siren is turned off, you do not need to wait for a full cycle)

2. Enter code as originally entered.

3. When correct code is entered the alarm will deactivate.

Manual Override Procedure

(LCD screen will confirm code)