User's Manual

Alarm Triggers

When the system is triggered, the siren will sound and the turn signal lights will flash. The transceiver’s

LCD will display the following messages:

1. If bike is bumped, the LCD will display

icon. The siren on the bike will sound for 5

seconds and the lights will flash. This cycle will repeat twice.

2. If the perimeter sensor triggers a full alarm cycle, the LCD will display icon. The siren on

the bike will sound for 5 seconds. This cycle will repeat twice

(Note: The turn signal lights will not flash for a perimeter sensor trigger).

3. If the bike is tilted, the LCD will display icon. The siren on the bike will sound for 30

seconds and the lights will flash. This cycle will repeat six times.

4. If the ignition switch is turned on or tampered with, the LCD will display

Icon. The siren on

the bike will sound for 30 seconds and the lights will flash. This cycle will repeat six times.

5. If the main harness or battery power supply is disconnected (assuming optional Back-Up

battery is installed), the LCD will display icon. The MCM-9 will still continue to sound

and transmit from its internal power source. The siren on the bike will sound for 30 seconds.

This cycle will repeat six times.

6. The transceiver will continue to flash the triggered icon until any button is pressed.

Transceiver Information