User guide

Commands When you see the
prompt you have the option of the following commands.The table below lists all currently
available commands and their associated data bytes.As may be seen, the majority of MIDI and
Internal Commands use a command followed by one or two variables.
MIDI Command Data Byte # 1 Data Byte # 2
•
End of data
Controller Controller number Controller value
F0 Begin SysEx “See “”SysEx Explained”””
Note-on Note number Velocity
Note-off Note number Velocity
Program change Program number
NRPN MSB only
NRPN MSB + LSB See below and
RPN MSB only NRPN/RPNs explained
RPN MSB + MSB
Pitchbend Pitchbend LSB Pitchbend MSB
Mono aftertouch Aftertouch amount
Poly aftertouch Note number Aftertouch amount
Controller Hi/Lo Controller number Controller value MSB/LSB
MTC Quarter frame Message type/value
F2 Song position pointer SPP Data LSB SPP Data MSB
F3 Song select Song number
•
Internal program Internal program number
•
Set global MIDI channel Global MIDI channel
•
Set internal clock rate Internal clock rate BPM
•
Set real-time value # 1 Real-time value # 1
•
Set real-time value # 2 Real-time value # 2
•
Internal clock start
•
Internal clock stop
•
Internal clock continue
F6 Tune request
F8 Timing clock
FA MIDI Clock start
FB MIDI Clock continue
FC MIDI Clock stop
FE Active sensing
FF System reset
Set MIDI channel 1
• = internal Freak data commands
Set MIDI channel 16 F0-FF = MIDI system data commands
•
Invert data All others are MIDI channel commands
NRPNs/RPNs Note that where MSB only and MSB + LSB are referred to in the command box below, this refers to
the Data MSB or Data MSB + LSB. Parameter MSB and LSB must always be defined and sent. For
further information see NRPNs explained on page 38.
Command Parameter MSB Parameter LSB Data MSB Data LSB
NRPN MSB only NRPN Cntrllr MSB NRPN Cntrllr LSB NRPN Data MSB
NRPN MSB + LSB NRPN Cntrllr MSB NRPN Cntrllr LSB NRPN Data MSB NRPN Data LSB
RPN MSB only RPN Cntrllr MSB RPN Cntrllr LSB RPN Data MSB
RPN MSB + LSB RPN Cntrllr MSB RPN Cntrllr LSB RPN Data MSB RPN Data LSB
````COMMAND`````
``End`of`DATA```
CONTROL FREAK COMMANDS
21