Technical data


9.3. SMS Control
When the AlarmManager cannot be accessed via the local network, it can be switched via SMS commands.
Trying to access without network connection, the app automatically starts into the corresponding menu,
when a telephone number for the AlarmManager is entered in the profile.
Before sending the SMS-text the message has to be confirmed.
9.4. MultiSensor-LAN / -LAN-RF / -RACK
To control a MultiSensor-LAN or MultiSensor-RACK in standalone mode connect to it via a profile - as
described for the AlarmManager. The device type must be set to „MultiSensor“.
After connecting an overview of the sensors measured values is displayed.
The button „Motion detection“ switches the arm/disarm state of the MultiSensor.
Via the button „Alarm output 2“ the 2nd digital output of the MultiSensor can be activated for 30 seconds.
Page  (04-2015, subject to change) kentix.com61
Note:
After an alarm was triggered the device can first be rearmed again after 1 minute.
For the switching functions (motion / digital output) the AlarmManager-communication in the MultiSensor
must be inactive.