Installation Guide

MODEL: 60515
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
READ INSTRUCTIONS ALL THE WAY THROUGH
PRIOR TO ASSEMBLY.
Assembly Time: 10 Minutes.
UNPACK THE SOLAR LED LIGHT STRING
The following parts should be included in your
solar light kits; (5) path lights, (1) solar panel,
(1) bracket and stake.
PANEL ASSEMBLY AND INSTALLATION
1.) Push tube and stake together as shown below.
2.) Attach bracket to back of the solar panel.
Position bracket & solar panel as shown below,
where the tab is on the bottom of the bracket &
the screw is on the same side as the power button
on the solar panel, the bracket will lock on to the
connector on the back of the solar panel by
pressing the tab against the back of the panel &
sliding the bracket upward, follow arrows on
diagram.
Note: You can adjust the angle of the solar panel
by loosing the screw.
4.) Insert the path lights and the solar panel
into the ground in a sunny area.
3.) Join the connectors and screw the cap
tightly together.
5.) Once charged for around 10 hours, your
solar LED path Lights are ready for use. Press
the power button on the back of the unit to turn
the lights on.
Timer