Installation Guide

Optional, if not using cord covers skip to step 7.

Place cord channel (F) on wall and mark holes. Drill

6 mm (1/4”) pilot holes on marked spots and insert

(2) anchors (M).

(If fastening to studs, skip this step.)

Attach cord channel (F) to wall with (2) supplied

screws (L). Place cords inside cord channel (F) and

press (2) cord covers (E) rmly on channel to secure.

51056SS ASSEMBLY INSTRUCTIONS

Fill the fountain body (B) with

1.7 gallons of distilled water.

Place decorative river stones (J)

onto pump access door (C).

Connect the light connectors

(H) and (I) and screw the cap

tightly.

Plug light transformer (H) and

pump (G) into outlets and

turn light on at switch.

Use water guiding pad (N) to

brush the fountain face.

FINAL STEPS

Note: Light does not have to be on to operate pump.

Hole in

wall