Installation Guide

Optional, if not using cord covers skip to step 7.
Place cord channel (F) on wall and mark holes. Drill
6 mm (1/4”) pilot holes on marked spots and insert
(2) anchors (O).
(If fastening to studs, skip this step.)
Attach cord channel (F) to wall with (2) supplied
screws (N). Place cords inside cord channel (F) and
press (2) cord covers (E) rmly on channel to secure.
51051ORB ASSEMBLY INSTRUCTIONS
Fill the basin (A) with 2/3
gallons of distilled water.
(a little below the max. ll line)
Place decorative river stones (J)
onto basin (A).
Connect the light connectors
(H) and (I) and screw the cap
tightly.
Plug light transformer (H) and
pump (G) into outlets and
turn light on at switch.
Use water guiding pad (P) to
brush the fountain face.
FINAL STEPS
Note: Light does not have to be on to operate pump.
O
F
F
E
N
Hole in
wall
7