Installation Guide

Optional, if not using cord covers skip to step 7.

Place cord channel (G) on wall and mark holes. Drill

6 mm (1/4”) pilot holes on marked spots and insert

(2) anchors (J).

(If fastening to studs, skip this step.)

Attach cord channel (G) to wall with (2) supplied

screws (I). Place cords inside cord channel (G) and

press (2) cord covers (F) rmly on channel to secure.

51034SLBL ASSEMBLY INSTRUCTIONS

Fill fountain body (A) with 1.3

gallons of distilled water.

(a little below the max. ll line)

Place decorative river stones (H)

onto pump access door (B).

Connect the light connectors (B)

and (C) and screw the cap tightly.

Plug light transformer (C) and

pump (D) into outlets and turn

light on at switch.

Use water guiding pad (K) to brush

the fountain face.

Use metal card (L) to clear water exit.

FINAL STEPS

Note: Light does not have to be on to operate pump.

Hole in

wall