Use and Care Guide

Maintaining Your Water Optimizer

Maintaining Your Water Optimizer 14

1/4 in. Quick Connect Shuto Valve, until the water exiting the lter is clear. Be sure

to aim the water outlet on the attachment into your container.

8. Now, disconnect the

Filter Flushing Setup from the

1/4 in. Quick Connect Shuto Valve and reattach it to the

Source Input Port

9. Next, if replacing the internal lter, open the

Internal Filter Door by inserting your

nger into the opening at the top, and pulling lightly down and outward.

10. Lay a towel down across the base of the internal lter cavity, to catch any water that

drips down, and prevent triggering

Leak Detection Sensor.

11. Replace the applicable lter(s) in the location(s). Filters can be removed by

twisting counter clockwise. To insert new lters, press lter upward into the

Internal Filter EZ-twist Mount and

External Filter EZ-twist Mount (if in use)

while twisting clockwise.

ULTRA+3 Hybrid Filter (DEFAULT - Internal Filter Slot)

Particle Filter (DEFAULT/OPTIONAL - External Filter Slot)

Polishing Filter (Alternative - Internal Filter Slot)

Chemical Filter (Alternative - External Filter Slot)

12. Reattach the

Internal Filter Door, and discard the old lter(s).

13. Open the

1/4 in. Quick Connect Shuto Valve, to enable water ow.

14. Place your container below the

Water Dispenser Nozzle one last time, then press

the

Ambient Dispense Mode Button, quickly followed by pressing and holding

the

Dispense Button until water ow is constant, to repressurize the system. Once

water is steadily dispensing, you can stop.

15. Plug

110v Power Cord back into the electrical outlet.

16. Finally, press and hold the

ECO Mode/Filter Rest Button for 5 seconds to reset

the timer and

Pod Filter(s) Status Light. You’re nished!