Refrigerator User Manual

Door
Door StOpper
HINGE LOCATION OF
A REVERSIBLE DOOR
Refer to the disassembly diagram and
change the door hinges in the following
procedure.
1. Tilt the refrigerator back or lay it on its back.
Use a pad or blanket to protect the floor and
to avoid scratching the painted finish.
2. Remove the leveling legs by turning them
counterclockwise. Remove the lower
hexagonal head screws, two on the hinge
side and one near the front corner of the
other side.
3. Pull the door away from the top table
assembly and set the door aside.
4. With a Philips plus screw driver, unscrew the
shaft hinge top and transfer to tile opposite
side.
5. Insert the door back to the shaft hinge top
which was screwed unto the opposite side.
6. Remove the refrigerator door hinge stopper
and the hinge stopper screws and install
them on the other side of the door.
7. Screw the bottom hinge in place ensuring
the door is properly secured.
8. Screw the remaining leg to the otl-,er side.
. The direction in which the door opens has
now been changed; however, the following
points should be checked:
a. Make sure the door is on straight.
b. Make sure that there is no space
between the door gasket and the
refrigerator unit itself when the door is
closed.
C. Make sure that the gasket on the hinge
side is not caught between the door
and the unit when the door is opened
or closed. (If the door is forced closed
when the gasket is caught, the gasket
may be damaged.)
When checking the above points, if it is
discovered that the door is not installed
properly (this is apt to happen at the first
try), loosen the screws holding the upper
hinge, straighten the door and tighten the
screws slowly with the socket wrench. After
making sure that the door is installed
correctly, tighten all the screws holding the
hinge.
If they are not tightened, the door may slip
out of position or there may be an opening
between the door and the unit.