Installation guide

Installation Instructions
OUTSIDE BACK EXHAUST (Horizontal Duct)
INSTALLATION OVERVIEW
BI. Prepare Rear Wall
BZ. Remove Blower Plate
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
BS. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
• Make sure the screws for the
blower motor and blower plate
are securely tightened when i !p I II !
they are reinstalled. This will _---_ I II I /
help to prevent excessive _- __ ......._ I II I /
vibration. W "_ "_ I _A
been properly routed and secured, __
and that the wires are not pinched. _ _ _ /
I _ II __NT .'Do not remove the cardboard
;pa;;Jb;iw;enih;h;a&hi_ld-a-.ddoor.
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
• Read the instructions on the REAR
WALL TEMPLATE.
• Tape it to the rear wall.
• Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
REMOVE BLOWER PLATE
Remove and save the screw that holds the blower
plate to the microwave. Lift off the blower plate.
BlowerPlate
_ Backof
Microwave
EN-16