Installation guide

Installation Instructions
B6.; MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
NOTE: When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1-3. Do not pinch cord or [1 Lift microwave, tilt it
lift oven by pulling cord. forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
[2 Rotate front of oven
up against cabinet
bottom.
|3 Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Cabinet Front
J Cabinet Bottom Shelf
meet
/ va Filler Block
| Equivalent
1
| to Depth
of Cabinet
Recess
SN \ Self-Aligning Screw
Microwave Oven Top
DG
4 | Attach the microwave oven to the top cabinet.
[5 | Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
6 | Tighten center
screw completely.
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
| 8 [Install grease filters. See the Use and Care
packed with the microwave.
EN-19