Installation guide

Installation Instructions
B | OUTSIDE BACK EXHAUST (Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Blower Plate
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
* Make sure the screws for the
blower motor and blower plate
are securely tightened when
they are reinstalled. This will
help to prevent excessive ¢..
vibration. “>
eowenscenagewensceeetenpenenenetenceneesnetencens
fi
‘
i
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
B1.| PREPARING THE REAR WALL B2.; REMOVE BLOWER PLATE
FOR OUTSIDE BACK EXHAUST
Remove and save the screw that holds the blower
You need to cut an opening in the rear wall for plate to the microwave. Lift off the blower plate.
outside exhaust.
Blower Plate
a | ™e___ Back of
Microwave
* Read the instructions on the REAR
WALL TEMPLATE.
* Tape it to the rear wall.
* Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
EN-16