Installation guide

Installation Instructions
A2.| USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
* Read the instructions on the TOP CABINET
TEMPLATE.
* Tape it underneath the top cabinet.
* Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
A3.| ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
1] Place the microwave in its upright position,
with the top of the unit facing up.
Blower Plate
Back of
™“*- Microwave
Blower Motor
Screw
Remove the screw that holds the blower plate
to the microwave. Remove and save the screw
holding the blower motor to the microwave.
[2] Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
End B
End A
Back of
Microwave
Roll the blower unit 90° so that fan blade
openings are facing out the top of the
microwave.
Before Rotation After Rotation
a
Back of
Microwave
Back of
Microwave
4 | Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Top
Microwave
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
EN-13