Installation guide

Installation Instructions
A
OUTSIDE TOP EXHAUST (vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Adapting Microwave Blower for
Outside Top Exhaust
Check Damper Operation
Mount Microwave Oven
Adjust Exhaust Adaptor
Connect Ductwork
Ad.
AS.
A6.
A7.
IMPORTANT NOTES:
* Make sure the screws for the
blower motor and blower plate
are securely tightened when
they are reinstalled. This will
help to prevent excessive
vibration.
* Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
A1.| ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
1 | Remove the toggle wings from the bolts.
[2 | Insert the bolts into the mounting plate
through the holes designated to go into drywall
and reattach the toggle wings to %4” (19 mm) onto
each bolt.
To use toggle bolts:
Spacing for Toggles
More Than Wall
-ofa—ele— Thickness
i Toggle Wings
Mounting wl Toggle
Plate we J bat
Bolt End
3] Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the bottom of the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4] Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
EN-12