Installation guide

PARTS, TOOLS, MATERIALS
THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector One power cord clamp and
(for roof vented or wall vented installation). One dark-colored mounting screw
Not Actual Size (2 pieces must be assembled (to hold the power cord).
as shown} Actuai Size
Om |
Two power cord clamp bushings - Actual Size
(for the cord hole in a metal upper cabinet). aL
A
Cc
n
=
Two 1/4" x 2" lag screws - Actual Size Four 1/4" x 3" toggle bolts - Actual Size
(for wall stud holes). (for drywall holes}.
him
Twe tapping screws - Actual Size
Three 1/4" x 3" bolts - Actual Size (for attaching the damper duct connector}
(for securing to the upper cabinet).
One upper cabinet template
- Not Actual Size
Four spring toggle heads - Actual Size
(for the toggle bolts).
ZX One rear wail template - Not Actual Size
(3 pieces mounting plate only)
REAR wat TEMPLATE |
NOTE: You need fo install at least two lag screws into a 2" x 4" stud and four anchor bolts into the wall.
and the mounting area must meet the 150 Ibs. weight requirement.