Installation guide

Ae
2
aa
()
Z
ve
YOUR SAFETY FIRST
BEFORE YOU START
* Proper installation is the installer's responsibility!
- Read the entire manual before you begin.
- The model number label is located on the oven front of oven behind doon See Figure 1.
- Mounting plate is located on back side of microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
Model Number Label Mounting Plate
® |
] cy — ;
®
| (
& irre
0
By
ooo on] !
Model Number Label Mounting Plate
Figure | Figure 2
A WARNING A
FOR YOUR SAFETY:
* This oven should not be installed or located by anyone except properly qualified service personnel.
* You will need TWO people to install this oven. lt is heavy and could cause personal injury if not
handled properly.
* AVOID ELECTRICAL SHOCK!
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be
behind concealed the wall, YOU COULD GET AN ELECTRIC SHOCK it you contact electrical wires
with your drill bit.
- Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
* ELECTRICAL RATING OF THIS OVEN: 120V, 60Hz.
- You need a 120V, 6OHz, AC only, 15A or 20A, fused electrical supply (located in the cabinet above
the microwave as close as possible to the microwave circuit) serving only the microwave.