Installation guide

STEP 3: PREPARE THE VENTING BLOWER
. Reassemble the blower wire. See Figure 15.
Oa
. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 17.
When you insert blower unit, blower wire must be like Figure 16.
6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet.
See Figurel 7.
7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned.
Attach with one blower unit mounting screw and then one blower plate mounting screw. See Figure 18.
Figure 16 Figure 15
Roof-Vented Installation:
1. Remove one blower unit mounting screw and one
or two blower plate screw(s). Remove the blower
plate from cabinet. See Figure 19.
2. Use side cutter or thin snips to cut and remove
knockouts "A" from Blower plate. Discard
knockouts. Be careful not to distort the plate.
See Figure 20.
3. Carefully lift the blower unit out of the microwave
oven.
4. Rotate blower unit 90°so the exhaust ports face
the top of the cabinet. See Figure 21.
5. Reassemble the blower wire.
oO . Place blower unit back into microwave oven.
7. Reattach blower plate to microwave oven. Attach
with the one blower unit mounting screw and then
the one or two blower plate mounting screw(s).
See Figure 22.
8. Attach the exhaust adapter to the blower plate
by sliding it into the Guide. See Figure 23.
Blower unit
Blower plate
Figure 21
QS"
Se Bower plate
Figure 22
exF
Exhaust Ports
Figure 17
g-———- Blower plate
~} Mouning Screw (option)
Blower plate
aS)
ECO)
ye
Blower unit
Back plate
Blower unit !
exhaust ports “a Blower unit mounting
screw (option)
Figure 18
t___— Blower plate
jen ““iMouning Screw (option)
Blower plate
Back plate
ow
a ss “ey Blower unit mounting
Parts "B" screw (option)
Figure 19
Knockouts “A”
aA NS
Blower plate
Figure 20
Exhaust
, adapter
|
ee
- Sain Back of oven
<a
Blower plate
mounting
_screw (option)
ie
ae
mounting
screw (option)
Figure 23
1