Installation guide

STEP 3: PREPARE THE VENTING BLOWER
WALL VENTED INSTALLATION
1. Remove one blower unit mounting screw and two
blower plate screws. Remove the blower plate Blower unit
from cabinet. See Figure 12.
Back plate
_- Blower plate
2. Carefully lift the blower unit out of the microwave i mounting screws
oven. Disconnect the blower wire from connector.
See Figure 13.
3. Use side cutters or tin snips to cut and remove Knockouts "B"
knockouts "B"from Back plate.
Discard knockouts. Be careful not to distort
the plate. See Figure 14.
Blower plate
P Blower unit
mounting screw
Figure 12
4. Rotate the unit so that the exhaust ports face the
rear of the cabinet. See Figure 15. Before you
insert blower unit, blower wire must be like
Figure 15.
5.
Reassemble
the
blower
wire
into
the
connector.
Blower
wire
6. Place blower unit back into cabinet. Check that
the exhaust ports face towards the rear of the
cabinet. See Figure 16.
aS)
ECO)
ye
7.
Reattach
the
blower
plate
to
the
top
of
the
cabinet
Connector
as it was originally assembled. Attach with one
blower unit mounting screw and then two blower
plate mounting screws. See Figure 17.
8. Go to STEP 4, PREPARE THE WALL AND UPPER
CABINET FOR INSTALLATION located on page 13.
Blower unit
Exhaust ports
Blower plate
mounting
screws
Blower unit ~
Exhaust ports exhaust ports “\
Blower unit
mounting screws
Figure 16 Figure 17
N