Installation guide

I
' 11-:/e"
0
'3
m
I
.
3.
r
.
5.
.
thicknessareontemplate.
Alignupper-cabinettemplatecenterlinewithcentarlineofmountingplate.
Securelytapeortackupper-cabinettemplateinplace.
I1 If II
Drilla 3/8 diameter holeintouppercabinetat points J and "K".
- If bottom of upper cabinet is recessed, make 2 fillerblocksas the size of
the shadedareas "G" and "H".
You may need tocutthe fillerblockto fit insideuppercabinetframe.
Markthe cutoutpositiononthe filler blocksthroughthe holes onthe cabinet
bottoma 3Is" die. hole at work in each block.
Placethefiller blocksso that the hole ineach blocklines upwiththe 8/8"
cutoutin the bottomof thecabinet.
Tape fillerblocksto cabinetbottomafter template isremoved.
Cut ordrill 2"dia, power supply cord hole "M". Installbushingifcabinetismetal
Determinewhicheverventingmethodyouneed.Productisassembledfor
Roomvented(recirculation)installation.Adjustmentsmustbemadeforwallvented
androofventedinstallations.See InstallationInstructions.
- To ventthroughroof,cutoutarea"L" onuppercabinettemplate.
Roofventedlocationcanbeadjustedfora non-recessedcabinet.
GotoSTEP3,ininstallationInstructions.
- Toventthroughthewall,gotoSTEP3, inInstallationInstructions.
- Forroomventedinstallation,gotoSTEP4, inInstallationInstructions.
Removetemplate.Completeinstallationaccordingtomicrowaveoven
InstallationInstructions
1/2" 3h" 1" 1-1/4"
I
i
i
i
The "Rearwall" arrowsmust
be againstthe rear wall so that
the holescut in the cabinet bottom
and the holes in the top of the
microwavecabinetwill align.
Rear
wall
8" 5/16"
The "Rearwall" arrowsmust
beagainstthe rear wall so that
the holescut in the cabinet bottom
and the holes inthe top of the
microwavecabinetwill align.
Rear
wall
ml
m
mml
Q
mlb
|
.4=,
r
mlb
I%:)