Installation guide

STEP 6:

ATTACH THE OVEN TO THE WALL

6. Roof-vented installation: Align the damper/duct connector

with the vent on top of the microwave oven. Damper

should be on top of tab. Use two tapping screws(bright-

colored) to attach damper/duct connector to the microwave

oven. See Figure 36.

NOTE: Damper/duct connector must be attached to

microwave oven after microwave oven is installed.

7. Roof venting installation: Install ductwork through the vent

opening in the upper cabinet. Complete the venting system

through the roof according to the method needed. See

Figure 37. See "PREPARE THE VENTING SYSTEM,"

STEP 2 on the page 8. Use caulking to seal exterior roof

opening around exhaust cap. See Figure 6 on page 8.

8. Use power supply cord clamp to bundle the power supply

cord. Install power supply cord clamp, using screw as

shown in Figure 37, to inside of the cabinet.

9. Grasp filter screen with one hand holding the ring and the

other hand holding the opposite end. Insert the end of the

filter screen without ring into the opening and slide towards

the side of the microwave oven. Insert ring end of filter

screen into the opening and slide entire screen towards the

center of the microwave until screen is securely in position.

Repeat for other filter screen. See Figure 38.

10. Plug in the power supply cord.

11. Read your Owner's Manual, then check the operation of

your microwave oven.

Figure 35

[ damper _ I

I ,

Figure 36

.........b ]..........

Figure 36 Detail

duct I1-:-] %\H I \power

/ I I cord

/ _ "_=_'_ I clamp

I ,

Figure 37

Figure 38

--16--