Installation guide

STEP 3:

PREPARE THE VENTING BLOWER

Your microwave oven is shipped with the blower assembled for room-vented(recirculating). You need to

adjust the blower if you want wall-venting or roof-vented installation.

WARNING

ELECTRICAL SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT.

• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could

result in electrical shock.

REMOVE THE MOUNTING PLATE:

1. Remove any shipping materials and parts from

inside the microwave oven.

2. Cover the counter top or cooktop with a thick,

protective covering to protect it from damage and

dirt. See Figure 10.

NOTE: If you have a free-standing range,

disconnect it, move it onto a piece of

cardboard or hardboard and pull it away

from the wall, so that you can get closer to

the upper cabinet and back wall for easier

measuring and drilling.

3. Remove mounting plate screw(s) (1 or 2 screws)

from the mounting plate as shown and discard.

(See Figure 11.)

4. This plate will be used as the rear mounting plate.

(It will be used to locate and mark the mounting

holes on the rear wall.)

5. Locate exhaust adaptor, grease filters and

hardware packet.

6. At this point, remove any adhesive tape (if there is

any), on the exhaust adaptor, the grease filters

and the power supply cord.

A thick, protective

covering

_l___ Figure 10

o°

Mounting

plate

Mounting plate

screw(s)

(1 or 2 screws)

Control panel side

Figure 11

ROOM-VENTED INSTALLATION:

Go to STEP 4 on page 13.

ml0m