Product Data Sheet

3/8" NPT dryer pipe

NOTE: For a garage installation, the gas pipe height must be

an additional 18" (460 mm) from the  oor.

GAS SUPPLY CONNECTION REQUIREMENTS

■ Use an elbow and a 3/8"  are x 3/8" NPT adapter  tting

between the  exible gas connector and the dryer gas pipe,

as needed to avoid kinking.

■ Use only pipe-joint compound. Do not use TEFLON

tape.

■ This dryer must be connected to the gas supply line with a

listed  exible gas connector that complies with the standard

for connectors for gas appliances, ANSI Z21.24 or CSA 6.10.

BURNER INPUT REQUIREMENTS

Elevations above 2,000 ft. (610 m):

■ When installed above 2,000 ft. (610 m), a 4% reduction of the

burner Btu rating shown on the model/serial number plate is

required for each 1,000 ft. (305 m) increase in elevation.

Gas supply pressure testing

■ The dryer must be disconnected from the gas supply piping

system during pressure testing at pressures greater than 1/2 psi.

DRYER GAS PIPE

■ The gas pipe that comes out through the rear of your dryer

has a 3/8" male pipe thread.

INSTALL LEVELING LEGS

1. Prepare dryer for leveling legs

Firmly grasp dryer body (not console panel) and gently lay

dryer down on back cardboard corner posts.

IMPORTANT: If laying dryer on its back, use the cardboard

corner posts the dryer was packed with to avoid damaging

the back of the dryer.

2. Screw in leveling legs

Using a wrench and tape measure, screw leveling legs into leg

holes until bottom of foot is approximately 1" (25 mm) from

bottom of dryer.

Now stand the dryer on its feet. Slide the dryer until it is

close to its  nal location. Leave enough room to connect the

exhaust vent.

For mobile home use

Gas dryers must be securely fastened to the  oor.

Mobile home installations require a Mobile Home Installation

Hold-down Kit (Part Number 346764). For ordering

information, please reference “Assistance or Service” section

in the Use and Care Guide.

/2"

(38 mm)

/4"

(146 mm)