Installation guide

Plate position - beneath flat bottom cabinet
At least 30" —~——3u..
Draw a vertical line on the wall at the center of the 30”
wide space.
Tape the Rear Wall Template onto the wall matching the
centerline and touching the bottom of the cabinet.
Plate position - beneath framed recessed cabinet bottom
=
30" to Cooktop
Draw a vertical line on the wall at the center of the
30” space.
Tape the Rear Wall Template onto the wail
matching the centerline and touching the bottom
cabinet frame.
Plate position ~ beneath recessed botiom cabinet with
front overhang
Draw a line on the back
wall equal to the depth of
the front overhang.
Perr f
| pi 30” to Cooktop
oY
8505_XAA_03807A-EN+MES.indb 9
Your cabinets may have decorative trim that interferes with
the microwave installation. Remove the decorative trim to
install the microwave properly and to make it level.
THE MICROWAVE MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back
or side frame, install the mounting plate down the same
distance as the front overhang depth. This will keep the
microwave level.
|. Measure the inside depth of the front overhang.
2. Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside depth
of the front overhang.
3. For this type of installation with front overhang only,
align the mounting tabs with this horizontal line, not
touching the cabinet bottom as described in Step D.
2010-07-08 6:52:58