Installation guide

4. Attach the microwave oven to the top cabinet.
Cabinet Front
Cabinet Bottom Shelf
A / Filler Block
4 Equivalent to Depth
. of Cabinet Recess
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
COIN
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS N , Self-Aligning Screw
MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during installation. Microwave Oven Top
NOTE: If your wall cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord. 5. Insert 2 self-aligning screws through outer top cabinet holes.
NOTE: We recommend using filler blocks if the cabinet has Turn two full turns on each screw.
a front overhang.
IMPORTANT: If filler blocks are not used, case damage
may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1-3. Do not pinch
cord or lift oven by
pulling cord.
1. Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
6. Tighten the outer two screws to the top of the microwave
oven. (While tightening screws, hold the microwave oven in
place against the wall and the top cabinet.)
[|S
2. Rotate front of oven
up against cabinet
bottom.
3. Insert a self-aligning screw through top center cabinet hole.
Temporarily secure the oven by turning the screw at least
two full turns after the threads have engaged. (It will be
completely tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially when
mounting flush to bottom of cabinet.
7. Install grease filters. See the Owner’s Manual packed with
the microwave.
13
8505_XAA_03807A-EN+MES.indb 13 2010-07-08 6:53:02