Installation guide

Installation Instructions

D_ ALIGNING THE WALL PLATE

Horizontal Line

_zz ...............

Hole A

Area E

REAR WALI_ TEMPLATE

Centerline Draw a Vertical Line

notches on Wall from Center

of Cabinet

Hole C

CAUTION: Wear gloves to avoid cutting

fingers on sharp edges.

Hole B Horizontal Line

Draw a Horizontal line on wall from

bottom of "Rear Wall Template".

1. Draw a Vertical line on the wall at the center of the

30" wide space.

2. Draw a Horizontal line on the wall at the bottom of

"Rear Wall Template".

3. Drill 5/8" holes for toggle bolts on 3 locations

(Hole A, Hole B, Hole C) but if the location of hole

is same as that of stud, drill a 3/16" hole for wood

screw. In other words, toggle bolt can not be used

to the location of stud.

NOTE: DO NOT MOUNT THE PLATE AT THIS

TIME.

NOTE: Holes A, B and C are inside area E. If none of

A, B and C is in a stud, find a stud somewhere in area

E and draw a forth circle to line up with the stud. It is

important to use at least one wood screw mounted

firmly in a stud to support the weight of the

microwave. Set the mounting plate aside.