Installation guide

Installation instructions
:ul_, ,u,,i,,,,u, u,, i , u:,mrml , , ,,u .................
[_ ADAPTING MICROWAVE
BLOWER FOR TOP EXHAUST
(cont.)
[]Slide the exhaust adapter onto the bIower plate,
[_ Replace blower' plate with the screw removed in
Step !..
?
i
Backof
MicrowaveHoed
[_ Secure blower unit to microwave hood with the
screw removed in Step 1.
Backof Microwave
Hood
BlowerMotor
Screw
1_ MOUNT THE MICROWAVE
HOOD
FOR EASIER INSTALLATION AND PERSONAL,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE HOOD.
IMPORTANT: Do not grip or use handle
during installation.
21
Z: "lll'l"j![ !I!ILI'I , i I!! l'l'J'±!lll !!!!
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shell
IMPORTANT: If F_er blocks are not used,
case damage may occur from overtightening
screws.
NOTE: When mounting
the microwave hood,
thread power cord
through hole in bottom of
top cabinet., Keep it tight
throughout Steps 1-.3,
Do not pinch cord or
lift microwave hood
by pulling cord,
[_L.ift microwave hood,
tilt it forward, and
hook slots at back
bottom edge onto
four lower tabs of
mounting plate
2_Rotate flont of microwave
hood up against cabinet
bottom
[_Insert a self:aligning screw through top center
cabinet hole. Temporarily secure the microwave
hood by turning the screw at least two full turns
after the threads have engaged. (It will be
completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the
cord, especi,'flly when mounting flush to bottom
of cabineL
CabinetFront
/ CabinetBottomShelf
F-¢1 t / FillerBlock
I %:::7
MicrowaveHoodTop
iiilll