Manual

¢onve ing to LP Gas (ooot oued)
Converting Surface Burners on
Models Equipped with Sea ed Burners
(See Step 3 if range is equipped with Dual Burners.)
Burner cap
Burner head
Screws
Burner base
Orifice spud
1. Remove the grates, burner caps and burner heads.
2. Using the torxdriver, remove the burner bases by
unscrewing the 3 small screws in each base. Lift
the burner straight out.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each burner
base by unscrewing the spud from the fitting with a
7mm or a small adjustable wrench (depending on
the size of your spuds). Apply a 314" wrench to
the hex on the gas inlet tube as a back-up when
removing spud to prevent the aluminum tube
from twisting.
4. Install orifice spuds according to one of the
following diagrams (see [] or []), for LP gas or nat-
ural gas, depending on which you are converting to.
[_ Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care manual. LP orifice spuds have a 2-
digit number and the letter "L" on one side. Each ori-
fice spud will also have 1 or 2 grooves on one side,
denoting the location on the range where it is to be
installed as shown below.
: :::: ::L::i_ !i:::;!i ¸
Orifice Spuds for Converting to Natural
Natural gas orifice spuds have a 3-digit:
one side. Each orifice spud will also have::1:;: 2 o_::3::::::::::
grooves on one side with the letter
denoting the location on the range Where it is
installed as shown below.
5.
6.
Front of Range
To prevent leakage, make sure the orifice spuds
are securely screwed into the gas inlet tubes. Use a
small wrench to hold the inlet tube hex to prevent it
from twisting.
Put old orifice spuds back in the bag to save for
possible future conversion.
NOTE: If an orifice spud is _-_..
accidentally dropped, the --_..'_%____
cooktop can be raised by _
disengaging the 2 front
clips with a large flat blade
screwdriver.
DO NOT attempt to raise the cooktop without
removing all 4 burner bases.
If wires were disconnected to remove the cooktop,
feed wires through the burner holes in the cooktop:
Attach to each burner electrode terminal carefullyi
making sure not to bend the terminal. Then lower
cooktop until it snaps over the clips.
Electrode
Tail Screw --
Front of range
7. Carefully insert burner bases straight down with:the
tube over the orifice spud. Replace the screws,
making sure the tall screw is opposite the burnL
er electrode in each burner base;
38