Product Data Sheet

5
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
6
ThemetalangeundereachsideofthecooktopMUST be placed
over the cabinet countertop for proper unit support. The glass cooktop
should NOT directly touch on the countertop (see illustration 2) or
could cause glass breakage voiding the warranty. Level the unit if
needed.
7
After the installation, MAKE
SURE that the unit is
supported by the leveling
legs and NOT by the
cooktop.
1
Thecounter-toparoundthecut-outshouldbeatandleveled(see
hatched area on illustration 1)
H1
H2
H3
H4
Illustration 1
Shave Raised
Edge to Clear
Space for a
31 5/16" (79,5
cm) Wide
Cooktop.
1 ½" Max.
(3,8 cm Max.)
Illustration 2
To successfully
install the
range, the
initial level
height from
oorto
underside of
cooktop frame
should be at
least 1/16"
(0,16 cm) taller
than cabinet
sides as
measured in
step 2.
Metal
Flange
To avoid breakage: Do NOT handle or manipulate the
unit by the cooktop.
2
Before installing the unit,
measure the heights of
the two (2) cabinet sides
(H1-4), front and back
(see illustration 1) from
theoortothetopofthe
counter.
3
Level the range using the leveling legs and leveling
device (if equipped) so that the height from the
oortotheundersideofthecooktopglassframeis
greater than the tallest cabinet measurement by at
least 1/16" (0,16 cm) (see illustration 2).
4
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of
the cabinet cut-out.
5
Remove the protective channels on each side of the cooktop (if provided).