Installation guide

Installation Instructions

USE TOP CABINET TEMPLATE

FOR PREPARATION OF TOP

CABINET

You need to drill holes for the top support screws,

a hole large enough for the power cord to fit through

and a cutout large enough for the exhaust adapter.

• Read the instrucdons on the TOP CABINET

TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when drilling holes

in the cabinet bottom.

[_ ADAPTING BLOWER

FOR TOP EXHAUST

_J] Remove and save screws that hold blower plat e to

the oven.

,_ _ -'<-- BlowerPlateScrews

._- Backof Oven

_] Slide the blower plate from under its

retaining

flange and lift it off. Remove and save screw that

holds the blower motor to oven.

Retaining

"_ BlowerPlate

Screw

[] Carefully. pull out the blower unit. The wires

will extend far enough to allow you to adjust the

blower trait.

[] Roll the blower unit 90 ° so that fan blade openings

are facing up.

R011

NOTE: Make sure wires remain routed in the

grooves of the motor frame.