Installation guide

Installation Instructions

OUTSIDE TOP EXHAUST (Vertical Duct)

INSTALLATION OVERVIEW

C1. Attach Mounting Plate to Wall

C2. Prepare Top Cabinet

C3. Adjust Blower

CA. Install Adapter

C5. Mount Oven

C6. Adjust Exhaust Adapter

C7. Connect Ductwork

I-_ ATTACH THE MOUNTING

PLATE TO THE WALL

Attach the plate to the wall using toggle bolts. At

least one wood screw must be used to attach the

plate to a wall stud.

[] Remove the toggle wings from the bolts.

[] g

Insert the bolts into the mounting plate throu h

the holes designated to go into drywall and

reattach the toggle wings to Y_"onto each bolt.

To use toggle bolts:

Mounting

Plate.

SpacingforToggles

Mare ThanWall

-_.,--_Thickness

[eWings

BoltEnd

[] Place the mounting plate against the wall and

insert the toggle wings into the holes in the wall

to mount the plate.

NOTE: Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate

touch the bottom of the cabinet when pushed flush

against the wall and that the plate is properly

centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers

between the back of the mounting plate and the wall.

[_] Tighten all bolts. Pull the plate away from the wall

to help tighten the bolts.