Installation guide

Installation Instructions

PLACEMENT OF THE MOUNTING PLATE

I-_ REMOVING THE OVEN FROM

THE CARTON/REMOVING THE

MOUNTING PLATE

[] Remove the box containing the installation

instructions, filters, exhaust adapter, damper

and the small hardware bag. Do not remove

the Styrofoam protecting the front of the oven.

[] Fold back all 4 carton flaps fully against carton

sides. Then carefully roll the oven and carton over

onto the top side. The oven should be resting in

the Styrofoam.

[] Pull the carton up and off the oven.

[_The mounting plate is attached to the back of the

oven. Remove the two screws holding it to the oven.

The plate will be used as the rear wall template and

for mounting the oven to the wall.

[_Set the oven upright. Remove and properly discard

plastic bags and Styrofoam.

[] Open the oven door and remove the styrofoam

pack from inside the oven. Remove the tape

covering the turntable hub.

[] FINDING THE WALL STUDS

ii wail i i

Center_i if!

[] Find the studs, using one of the following

methods:

A. Stud finder - a magaaetic device which

locates nails.

B. Use a hammer to tap lighdy across the

mounting surface to find a solid sound.

This will indicate a stud location.

[] After locating the stud(s), find the center by

probing the wall with a small nail to find file

edges of the stud. Then place a mark halfway

between the edges. The center of any adjacent

studs should be 16" or 24" from this mark.

]Draw a line down the center of the studs.

THE OVEN MUST BE CONNECTED TO AT LEAST

ONE WALL STUD.