Installation guide

Installation Instructions
TOOLS YOU WILL NEED
# 1and#2 Phillipsscrewdriver Pencil
]in snips(forcutting
damper,if required)
G]oves
Safetygoggles
Scissors
(to cuttemplate,if necessary)
Saw (saber,holeorkeyhole)
Rulerortapemeasure
eight edge
Electricdrill with 3Ag'._6".
Vz"and_" drill bits
Studfinder or
Hammer(optional)
Level
Carpentersquare
(optional)
Fillerblocksor scrap
woodpieces,if needed
for topcabinetspacing
(usedonrecessedbottom
cabinetinstallationsonly)
Ductandmaskingtape
MOUNTING SPACE
66"ormore
fromthe floor
to thetopof
theoven
Bottomedgeof
cabinetneedsto
be30"ormore
the cooking
surface
NOTES:
• The space between the cabinets must be 30" wide
and free of obstructions.
• If the space between the cabinets is greater than
30;'a Filler Panel Kit may be used to fill in the
gap between the oven and the cabinets. Your
Use & Care Guide contains the kit number for
your model.
• This oven is for installation over ranges up to
36" wide.
• If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the inswuctions on
the top cabinet template for power cord clearance.
7