Installation guide

Installation Instructions

I_ Gently remove the wires from the

grooves.

Reroute the wires through grooves on other side

of the blower unit.

BeforeRerouting After Beroudng

Wires RoutedThroughRight Side Wires RoutedThroughleft Side

[_ Roll the blower unit 90 ° so that fan blade openings

are facing out tile back of the oven.

BeforeRolling

Oven Oven

[] Place the blower unit back into the opening.

EndA

CAUTION: Do not pull or stretch the blower unit

wiring. Make sure the wires are not pinched.

NOTE: The blower unit exhaust openings should

match exhaust openings on rein"of ovep_

_] Replace the blower in theplate posidon

same

as before with the screws.

,€. B'°B,eorwPLTws

BeokofOven

[_ Insert the tabs on each side of the damper into

file holes at the inside rear of the adapter.

_-_ Exhaust

Adapter

[_ Attach the exhaust adapter to the rear of the

oven by sliding it into the guides at the top center

of the back of tile oven.

ExhaustAdapter .,_

Slideexhaust _

adapterinto

guideson

oven rear. I._

_ Damper

(hingesideup)

_V "_'_r_ Screws

Tabs

, Guides

Push in securely until it is in the lower locking

tabs. Take care to assure the damper hinge is

installed so that it is at the top and that the

damper swings freely.

[_ Secure the exhaust adapter to the oven with the

two bronze metal screws provided.