Installation guide

Installation Instructions
To use toggle bolts:
Mounting
Plate
Spacingfor TogglesMore
ThanWall
Thickness
ToggleWings
all
BoltEnd
[] Place the mounting plate against file wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
[] Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
_-] USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
[_ ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
[_ Remove the three screws that hold the blower plate
to dae oven. Slide blower plate from under its
retaining flange. Remove and save the screw that
holds blower motor to oven.
_V
FRetn_gnei'___ "_r'_- BlowerPlate
[] Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
EndA
[] Roll the blower unit so the fan blade openings
are facing up.
BeforeRolling After Rolling
[4] Rotate blower unit counterclockwise 180 °.
BeforeRotation
After Rotation
3ackof
Oven
16