Installation guide

Installation Instructions

RECIRCULATING (Non-Vented Ductless)

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall

A2. Prepare Top Cabinet

A3. Mount Oven

A4. Install Charcoal Filter

NOTE: The exhaust adapter

with damper is not needed for

reeirculating models. You may

want to save it for possible

future use.

I-_ ATTACH THE MOUNTING

PLATE TO THE WALL

Attach the plate to the wall using toggle bolts.

At least one wood screw must be used to attach the

plate to a wall stud.

[] Remove the toggle wings from the bolts.

[2] Insert the bolts into the mounting plate through

the holes designated to go into drywall and

reattach the toggle wings to _" onto each bolt.

To use toggle bolts:

Spacingfor Toggles

MoreThanWall

-J_._---Thickness

Mounting

Plate

Bolt End

[_] Place the the wall andmounting plate against

insert the toggle wings into the holes in the wall

to mount the plate.

NOTE: Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate

touch the bottom of tile cabinet when pushed

flush against the wall and that the plate is properly

centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers

between the back of the mounting plate and the wall.

[] Tighten all bolts. Pull the plate away from the wall

to help tighten the bolts.