Installation guide

Installation Instructions

ALIGNING THE WALL PLATE

HoleC

Drawa Vertical

LineonWall

•,,e--frorn Centerof

TopCabinet

o o o

0 0 0 0 0 0 0 .b 0 0 0 0 O 0 0 0 0 0

0 0 0 O O OIO O O O O 0 0

CAUTION: Wear gloves

to avoid cutting fingers on

sharp edges.

_f I

AreaE

Hole D

[] Draw a vertical line on the wall at the center of the

30" wide space.

[_Use the mounting plate as the template for the rear

wall. Place the mounting plate on the wall, making

sure that the tabs are touching the bottom of the

cab'met or the level line drawn in Step C for cab'mets

with front overhang. Line up the notch and center line

on the mounting plate to the center line on the wall.

[] While holding the mounting plate with one hand,

draw circles on the wall at holes A, B, C and D (see

illustration above/actual plate marked with arrows).

Four holes must be used for mounting.

[]

NOTE: Holes C and D are inside area E, ff neither

C nor D is in a stud, find a stud somewhere in area E

and draw a fifth circle to line up with the stud. It is

important to use at least one wood sca'ew mounted

firmly in a stud to support the weight of the oven.

Set the mounting plat e aside.

Drill holes on the circles, ff there is a stud, drill a _i6"

hole for wood screws. For holes that don't line up with

a stud, drill a _" hole for toggle bolts.

NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.