Installation Guide

GAS COOKTOP INSTALLATION INSTRUCTIONS

Installing the transition to the blower

Attach the transition to the outlet of the blower using

four screws. Tape the joint to seal.

One screw per side

Wide Head Phillips Screws

Figure 19 – 36" MODEL

ATTACH PLENUM TO THE COOKTOP

Figure 20 –

ATTACH TRANSITION TO THE BLOWER

Install 4 Screws

Install Four #8-18 Black

Hex Head Screws

Figure 21 –

ATTACH BLOWER TO THE PLENUM

Figure 22 –

NUT LOCATIONS INSIDE THE PLENUM

Installing the blower to the plenum

Install four nylon insert nuts to the studs on the blower,

nger tighten until resistance is felt. Position the blower

discharge opening to match the ductwork. Slide the nuts

on the side of the blower housing into the four keyhole

openings on the side of the plenum and allow to slide

down into the slots. Using a wrench or ratchet from the

inside of the plenum tighten the nuts.