Installation Guide

GAS COOKTOP INSTALLATION INSTRUCTIONS
8
11
Installing the Cooktop
Lift the cooktop by the side edges as shown.
Lower the cooktop into the countertop opening, guiding
it into position. Support the underside and lower slowly.
Carefully remove your ngers one corner at a time to
lower the cooktop into position.
NOTE: DO NOT use Silicone RTV or caulk to seal the
cooktop to the countertop.
12
Installing the installation brackets
Remove screws from the cooktop chassis and use to
attach the hold down bracket to the bottom of the
chassis. Insert the screw into the bracket until it contacts
13
Installing the blower plenum to the cooktop
With the blower opening on the right slide the plenum
into the opening in the bottom of the cooktop.
Push up on the plenum until the mounting rails on the
sides of the plenum contact the bottom of the cooktop.
Install four #8 x 3/8” sheet metal screws to hold the
plenum in place.
Install Four #8-18 Black
Hex Head Screws
Figure 15 – LOWERING COOKTOP INTO CUTOUT
Cooktop
Screws Supplied
with Cooktop
Phillips Screw
Countertop
Screws Supplied
with Cooktop
Phillips
screw
Figure 17 – INSTALLATION BRACKETS
Figure 18 – 30" MODEL
ATTACH PLENUM TO THE COOKTOP
Figure 16 – ATTACH THE TWO BRACKETS
Two #8-18 Black Hex Head
Screws Attached to Cooktop
One Hold
Down Bracket
One Long
Phillips Screw
Figure 14 – DUCTWORK ALIGNMENT
10
Blower to Ductwork Alignment
The use of exible ducting is discouraged because it
can severely restrict airow. If the blower outlet and the
oor or wall duct location DO NOT align, then exible
METAL ducting can be used to adapt to an oset.
6" MAX.
Center line
To Center
line Oset
the backside of the countertop. To prevent damage to
the countertop, DO NOT overtighten the screw.