Installation Guide

GAS COOKTOP INSTALLATION INSTRUCTIONS
13
Figure 32
VENT GRATE AND SEAL LOCATION – 30" MODEL
Figure 33
VENT GRATE AND SEAL LOCATION – 36" MODEL
Vent Grate
Seal
Vent
Grate
Vent Grate
Vent
Grate
Seal
22
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
21.1
Turn on Electrical Power and Open Main Shuto
Gas Valve
21.2
Check the Igniters
Operation of electric igniters should be checked after
cooktop and supply line connectors have been carefully
checked for leaks and the cooktop has been connected
to electric power.
To operate the surface burner:
A. Push in and turn a surface burner knob to the LITE
position. You will hear a small ticking noise; this
is the sound of the electric ignitor which lights the
burner.
B. After the burner lights, turn to the desired ame
size. The controls DO NOT have to be set at a
particular mark. Use the marks as a guide and
adjust the ame as needed.
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the ow of combustion and ventilation air to
the cooktop is unobstructed.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to the warranty in your Use and Care Guide for
our service phone number and address. Please call or
write if you have inquiries about your product and/or
need to order parts.
• Place the vent grate on top of the vent grate seal, over
the vent opening. Place the burner grates over the
burners.