Installation Guide

GAS COOKTOP INSTALLATION INSTRUCTIONS
12
21
Install Filter, Vent Grate Seal and Grates
DO NOT operate the vent without the grease lter, vent
grate seal, screws, tab on vent grate seal, and vent
grate in place.
20
Install Burner Caps
A. Unpack the burner grates.
B. Burners: Unpack the Burner heads and burner caps.
Place the burner heads and caps on the matching
bases.
C. The caps should be level after installation
D. Be sure that all the burner caps burner head are
correctly placed BEFORE using your cooktop
Figure 30
VENT GRATE SEAL ATTACHMENT – 30" MODEL
Figure 31
VENT GRATE SEAL ATTACHMENT – 36" MODEL
Figure 29
VENT FILTER LOCATION – 36" MODEL
Vent
Chamber
Grease Filter
• Carefully place vent grate seal over the vent chamber
on the cooktop as shown in Figures 30 - 31. Make sure
the collar on the bottom of the seal is fully inserted
into the vent opening. Remove the 1/4" hex head
screw located in the vent chamber underneath the tab
on the vent grate seal. Bend the tab on the vent grate
seal down into the vent chamber and secure it with the
hex head screw.
Grease Filter
Vent Chamber
Figure 28
VENT FILTER LOCATION – 30" MODEL
Grease
Filter
Vent Chamber
Grease Filter
Vent Chamber
Vent
Chamber
• Place the lter diagonally through
the vent chamber.
• Make sure it rests, at an angle, on
the supports in the vent opening.
Hex Screw
Vent
Grate
Seal
Vent
Grate
Seal
Hex Screw
DO NOT operate the vent without the grease lter,
vent grate seal, screws, tab on vent grate seal, and
vent grate in place.