Installation Guide

GAS COOKTOP INSTALLATION INSTRUCTIONS
10
16
Blower electrical connection
Connect the 5-pin plug on the blower assembly to
the matching 5-pin receptacle on the bottom of the
cooktop.
Fold all wires into the wire box on the end of the blower
conduit. Fasten the wire box to the cooktop with two #8
x 3/8” making sure that no wires are trapped.
17
Connecting the Ductwork
Connect the ductwork prepared in Steps 8, 9 and 10 to
the blower transition duct.
18
Install Pressure Regulator
Install the pressure regulator with the arrow on the
regulator pointing up toward the unit in a position
where you can reach the access cap.
DO NOT make the connection too
tight. The regulator is die cast. Overtightening may
crack the regulator resulting in a gas leak and possible
re or explosion.
Assemble the exible connector from the gas supply
pipe to the pressure regulator in the following order:
1. manual shuto valve
2. 1/2" (1.3 cm) nipple
3. 1/2" (1.3 cm) are union adapter
4. exible connector
5. 1/2" (1.3 cm) are union adapter
6. 1/2" (1.3 cm) nipple
7. pressure regulator
Use pipe-joint compound made for use with Natural
and LP/Propane gas to seal all gas connections. If
exible connectors are used, be certain connectors are
not kinked.
Figure 23 – CONNECT BLOWER TO COOKTOP
Figure 25 – PHYSICAL ATTACHMENT OF THE GAS
LINE TO THE COOKTOP
All connections must be wrench-tightened
Flare
Union
Flare
Union
GAS FLOW
Manual
Shutoff
Valve
Pressure
Regulator
On
Off
Flexible
Connector
Access
Cap
Nipple Nipple
Figure 22 – GAS SUPPLY LINE
Figure 24 – GAS SUPPLY LINE