Manual

To reducethe chanceof "FLASH-BACK"(see
CAUTIONon page3) cleanthe burnertubesand
burnersbeforefullyassemblingyourgrill.Remove
the cotterpin from the rearundersideof each
burnerusinga pairof longnosepliers.Carefully
lift eachburnerupandawayfromthe gasvalve
orifice,thenreferto Figure1 andperformoneof
thesethreecleaningmethods:
1. Benda stiffwire,(a lightweightcoathanger
workswell) intoa smallhookas shownbelow.
Runthe hookthroughthe burnertubeand
insidethe burnerseveraltimesto removeany
debris.
2. Usea bottlebrushwitha flexiblehandle.Run
the brushthroughthe burnertubeand inside
the burnerseveraltimes,removinganydebris.
3. Use an air hoseto forceair througheach
burnertube.The forcedair shouldpassdebris
or obstructionsthroughthe burnerand out the
ports.
iF,, WARNtNG
The location of the burner tube with respect
to the orifice is vital for safe operation.
Check to ensure the orifice is inside of the
burner tube before using your gas grill. See
Fig. 2. If the burner tube does not fit over
the valve orifice, lighting the burner may
cause explosion and/or fire.
Figure 2
GASVALVE ASSEMBLY
ORIFICE BURNER TUBE
Figure 1
GAS COLLECTOR BOX
SPARK ELECTRODE ,_
ASSEMBLY \ BURNER
BURNER PORT
TO CLEAN BURNER TUBE,
INSERT HOOK HERE
................... OOT
/ COTTER PIN
BURNER TUBE
" Size 2 phillips screwdriver
'_ Size 4 phillips screwdriver
'_ Adjustable wrench
'_ Long nose pliers
'_ Open-end wrench, 11/16" size
', Protective work gloves
" Eye protection
4