Performance Series® LAN Station / Workbench Instructions Address: Phone: Fax: 10152 Liberty Lane Chisago City, MN 55013 651-213-1333 800-418-6897 www.kendallhoward.
Welcome to your new Kendall Howard Performance Series® LAN Station / Workbench. Here is a little information to get you started on assembling your LAN Station / Workbench. This instruction manual goes over the complete assembly of all four of the standard configurations. Please pay close attention to the series that you have purchased and follow along making sure you follow the steps that only pertain to your series.
What’s in the Crate? Right Leg Left Leg Left Upper Shelf Support Right Upper Shelf Support Upper Shelf Channel QTY 2 Cross Bar Work Surface QTY 1 Back Plate QTY 1 Upper Shelf Lower Shelf 1 1/2” Bolt - Black QTY 18 1 1/2” x 1 1/2” End Cap QTY 4 2 1/2” Bolt - Black QTY 4 1 1/2” x 2” End Cap QTY 4 Channel Nut QTY 8 3/4” Round End Cap QTY 14 1/4-20 Cross Head Screw - Silver QTY 14 Leveler QTY 4 Tools Needed: T -Handle Hex Wrench (Included) Phillips Head Screwdriver Cordless Drill* *If you a
Step 2 - ALL SERIES Step 1 - ALL SERIES *Please note that the number of screw locations varies by the size of the bench. Picture below is of a 48” bench. Work Surface Cross Bar(s) Left Leg Right Leg 1/4-20 Screw(s) 1 1/2” Bolt(s) *Make sure you are using the 1 1/2” size and not the 2 1/2” size. Step 4 - Step 3 - ALL SERIES 100 & 400 SERIES only have one bottom shelf. 200 & 300 SERIES have two bottom shelves. *Please note that the number of screw locations varies by the size of the bench.
Step 7 - ALL SERIES Step 8 This completes the assembly for the 300 SERIES & 400 SERIES! Rotate Leveler(s) *If you purchased the optional caster kit, install the casters instead of the levelers. Step 9 For the 100 SERIES & 200 SERIES continue to STEP 9. Step 10 100 SERIES & 200 SERIES 100 SERIES & 200 SERIES Leave Space 2 1/2” Bolt(s) *You will need the 2 1/2” bolts so they are long enough to go into the vertical channels.
Step 13 100 SERIES & 200 SERIES *Please note that the number of screw locations varies by the size of the bench. Picture below is of a 48” bench.
For details about product warranty, please visit www.kendallhoward.com DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and complete. However, Kendall Howard LLC makes no representations or warranties of any kind, expressed or implied, about whether the use of products contained herein would infringe any rights or the correctness, accuracy or reliability of the information contained herein or that said information covers all details, conditions or variations.
