Operation Manual
X8 MIG WELDER 2.3 Installation
8.
Attach the wire spool brake halves to the new wire spool by pushing them together inside the wire
spool. Tighten if necessary.
Note:
The spool brake is equipped with an optional wire tensioning feature, which keeps the wire feed
steady in short repeated welds and with heavy wire spools. To enable wire tensioning, attach
the spool brake hub to the wire spool so that the tightening knob is on the right, seen from the
front.
9.
Lower the wire spool to its socket.
Note:
Ensure that the wire spool is facing the right direction, the filler wire running from the top of the
spool to the feed rolls.
10.
Lift the pressure handle off of the feed rolls.
Install the filler wire:
OPERATING MANUAL | EN 45
©
KEMPPI | 2018-09-28