Operation Manual
26
Robot Gun Cleaning Station© Kemppi Oy 2016 1616
OPERATING MANUAL
15. UNMOUNTING
Unmounting may only be carried out by specialist personnel. Please make sure that the
shutdown procedures are strictly observed before the unmounting is started. Make sure
to include also the components integrated into the welding system.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
Observe the information given in Chapter 11.
16. DISPOSAL
For disposal, the locally applicable regulations, laws, provisions, standards, and guidelines
must be observed. For the welding torch system to be properly disposed of, it must be
unmounted rst.
17. MATERIALS
This product consists for the most part of plastics, steel, and non-ferrous metals. Steel and
non-ferrous metals can be melted down, so iron materials are almost innitely recyclable.
The plastic materials used are marked in preparation for appropriate sorting of the
materials for later recycling.