Operation Manual

15
Robot Gun Cleaning Station© Kemppi Oy 2016 1616
OPERATING MANUAL
10.2 Installing the injection unit
This section describes how to install the Robot Gun
Cleaning Station’s injection unit.
The injection unit’s parts are depicted in the gure below.
The numbering in the steps of the procedure refers to this
gure.
Figure 10: Injection unit
1. Cover for injection unit
2. Rubber gasket for welding torch’s gas nozzle
3. Thrust ring
4. Injection unit, complete
5. Adjusting screw for the dosing of anti-spatter uid
Proceed as follows:
1. Before you operate the device, mount the rubber
gasket, tting the gas nozzle of the welding torch.
Figure 11: Rubber gasket
1. Mark the gas nozzle diameter of the welding torch.
2. Loosen the cover (1).
3. Attach the rubber gasket (2) to the cover (1).
Insert the rubber gasket (2) into the cover (1) with light
pressure. The special design of these two components
prevents unintentional dropping of the rubber gasket.