Operation Manual

12
Robot Gun Cleaning Station© Kemppi Oy 2016 1616
OPERATING MANUAL
9.3 Wire-cutting device sub-assembly
The wire-cutting device sub-assembly is depicted in the
gure below.
Figure 6: Wire-cutting device sub-assembly
1. Wire-cutting device
2. Protection plate
3. Movable cutting plate
4. Fixed cutting plate
9.4 Sub-assembly accessories and options
This section describes the sub-assembly accessories and options.
Table 8: Sub-assembly accessories
Prism
Anti-twist fastening with a cylinder-head screw (M8×20) in the clamping device
(depending on the diameter of the gas nozzle)
Milling cutter
Milling cutter dimensions determined on the basis of the gas nozzle and torch
geometry for an immersion depth of up to 50 mm (the cutter is available for all
standard WH and robot torch versions)
Table 9: Sub-assembly options
Maintenance unit
ID 830.0075
Unit consisting of a lter regulator and oiler
The function of separating solid particles from the compressed air and adding
atomized oil to lubricate the pneumatically driven components