Instruction Manual
Table Of Contents
- 1. General
- 2. Installation
- 2.1 Installing power source mains plug
- 2.2 Installing cooling unit (optional)
- 2.3 Installing equipment on cart (optional)
- 2.4 Connecting welding gun
- 2.5 Installing earth return cable
- 2.6 Installing remote control (optional)
- 2.7 Installing and replacing feed rolls
- 2.8 Installing and replacing wire guide tubes
- 2.9 Installing and changing wire
- 2.10 Installing gas bottle and testing gas flow
- 2.11 How to get welding programs
- 3. Operation
- 3.1 Preparing welding system for use
- 3.2 Calibrating welding cable
- 3.3 Using control panel
- 3.3.1 Control panel: Home view
- 3.3.2 Control panel: Weld Assist
- 3.3.3 Control panel: Channels
- 3.3.4 Control panel: WPS view
- 3.3.5 Control panel: Welding parameters
- 3.3.6 Control panel: Weld history
- 3.3.7 Control panel: Info view
- 3.3.8 Control panel: Device settings
- 3.3.9 Control panel: Applying welding programs
- 3.3.10 Control panel: Weld data view
- 3.4 Additional guidance to functions and features
- 3.5 Pulse welding
- 3.6 Wireless connection (WLAN)
- 3.7 Using remote control
- 3.8 Changing welding polarity
- 3.9 Lifting equipment
- 4. Maintenance
- 5. Technical data
Master M 358
Operating manual - EN
4.1 Daily maintenance
Disconnect the power source from the mains before handling electrical cables.
Welding machine maintenance
Follow these maintenance procedures to maintain the proper functioning of the welding machine:
• Check that all covers and components are intact.
• Check all the cables and connectors. Do not use them if they are damaged and contact service for replacements.
• Check the wire feed rolls and the pressure handle. Clean and lubricate with a small quantity of light machine oil if
needed.
For repairs, contact Kemppi at
www.kemppi.com or your dealer.
Welding gun maintenance
For Flexlite GX MIGgun instructions, refer to userdoc.kemppi.com.
© Kemppi
71
1921980 / 2242